Parallel Transfer Over Lap Section- Shaft Mounted Gear Motor

 

  1. A Pair of combined Drive & Idler section side board 2/3 mm polished S.St AISI 304 / 316 parallel transfer over lap
  2. Connecting bars between side boards , S.St AISI 304 D=12 / 20 / 20x20 with M8 thread
  3. Bearing support UCF series with safety cap
  4. Flange with body thread – M8 for attaching the bearing support S.St AISI 304.
  5. Drive & Idler shaft S.St AISI 304.
  6. Drive sprocket & Idler wheel split execution.
  7. Chain guide profiles support S.St AISI 304 + Wear strips profile UHMW-PE.
  8. Wear strips for the carry run UHMW-PE.
  9. Wear strips for the return run UHMW-PE.
  10. Chain return support.
  11. Chain return guide.
  12. Flange with body thread – M8 for attaching one section to another S.St AISI 304 .
  13. End cover 2/3 mm thick made of polished S.St AISI 304 / 316+ PVC protection.
  14. Gear motor.

 


back

Parallel Transfer Over Lap Section- Shaft Mounted Gear Motor G

robotic
EMAIL: sam@robotic-apps.com

Accessibility